May 15, 2025 Leave a message

Does Polyaluminium Chloride Reduce pH in Water Treatment?

Polyaluminium chloride (PAC) is a widely used coagulant in wastewater and drinking water treatment. Operators often ask whether adding PAC changes the pH of the water being treated. The short answer is yes: the addition of PAC typically leads to a slight decrease in pH, because the hydrolysis of PAC releases hydrogen ions into the water. Understanding this effect is important for maintaining stable coagulation performance and meeting water quality standards.

Does PAC Reduce pH?

In most cases, yes. PAC contains hydroxyl groups and polynuclear aluminum species that continue to hydrolyze after dosing. During hydrolysis, hydrogen ions are released, making the treated water more acidic. The change is usually slight, but in low-alkalinity water or at high dosage the pH drop can become significant enough to affect coagulation efficiency and final water quality. pH monitoring and, where necessary, adjustment are therefore recommended during PAC application.

Why PAC Lowers Water pH

When PAC dissolves, the aluminum species undergo hydrolysis reactions in which each step liberates a proton. The released hydrogen ions are partly neutralized by the natural alkalinity of the water; if the water has limited alkalinity, the pH falls. This is the same mechanism that makes all aluminum and iron coagulants net acid producers, although PAC is less acidifying per unit of aluminum than aluminum sulfate because part of its neutralization has already occurred during manufacturing.

Factors That Affect the pH Shift

Dosage: higher PAC doses release more hydrogen ions and cause a larger pH drop.

Raw water alkalinity: water with high alkalinity buffers the acid and shows little pH change; soft, low-alkalinity water drops more.

Product type: PAC prepared by different methods and with different basicity values affects pH to different degrees.

Temperature and mixing: these influence hydrolysis kinetics and therefore the rate at which protons are released.

Monitoring pH During PAC Application

In practice, the pH should be measured before and shortly after PAC dosing, and again after flocculation if the process is continuous. A drop of 0.2 to 0.5 pH units is common in moderately buffered water, while larger drops can occur in soft water. Because coagulation performance is usually optimal in a specific pH window, typically between 5.5 and 8 for PAC, the operator should confirm that dosing keeps the system inside the effective range.

Adjusting pH with Alkali

If PAC application lowers the pH below the target range, the pH can be raised by adding an alkaline substance such as sodium hydroxide (NaOH), lime, or soda ash. Sodium hydroxide is commonly preferred because it is easy to dose and does not add hardness. The alkali can be added before, together with, or after the coagulant, depending on the process design; jar tests help determine the correct alkali dose and dosing point so that the final water quality meets specifications.

Frequently Asked Questions

Does polyaluminium chloride lower pH?

Yes, PAC typically lowers pH slightly because its hydrolysis releases hydrogen ions. The effect is usually small and depends on dosage and water alkalinity.

How much does PAC reduce pH?

The drop is commonly in the range of about 0.2 to 0.5 pH units in buffered water, but can be larger in low-alkalinity water or at high dosages.

How can I correct the pH after PAC dosing?

Add an alkaline chemical such as sodium hydroxide, lime or soda ash, dosing by jar test results to reach the target pH.

Is PAC more or less acidifying than alum?

PAC is generally less acidifying than aluminum sulfate per unit of aluminum, because a portion of the neutralization occurs during manufacturing.

Do different PAC products affect pH differently?

Yes, PAC prepared by different methods and with different basicity values can have different effects on pH, so the specific product should be evaluated in practice.

Why is pH control important in coagulation?

Coagulation performance depends on pH because it controls the charge and speciation of both the coagulant hydrolysis products and the particles being removed.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry